Appliance Trim Kit User Manual

B - 4 PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 GFK-1115
B
Errors While Working in PCS
When the PCS is running, error messages are either displayed in the bottom line of the screen (the
function key line) or in the current window.
Faults running PCS!
Check that the following condition is met:
■ FILES and BUFFERS in the CONFIG.SYS file should be set to at least the following
values:
BUFFERS = 10
FILES = 40
■ During installation, the SETUP program makes these settings automatically, but only if
you responded positively by pressing
Y during the installation process. If the BUFFERS
and FILES values in the CONFIG.SYS file are smaller, change them to the above values
before trying to run the PCS again.
Invalid Project Name
This error message appears in the last line if a new project is assigned a name that already exists.
Either change the new project's name or delete the existing project with the same name.
<File name> cannot be written
When entering project names or saving pictures, text groups, or key definitions, filenames must
meet the following conditions:
■ Maximum length of the filename: 8 characters
■ Only standard MS-DOS characters are allowed. Characters such as ".*?,;.:" or the
space character are not permitted.
<File name> cannot be read
This error message appears if a non-existent filename is entered while trying to load a project or
picture.
If no filename is entered and [ENTER] is pressed, all existing project or picture names are listed
in a selection window. By using the cursor keys to highlight a filename, the desired project/picture
can be selected and loaded.