Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
6 - 60 PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 GFK-1115
6
E. Now you can display a list of all alarms in this group by pressing the F5 Alarm List key
while in the Alarm Group List window. (Press PgeDn to view the remainder of the
Alarm List window.)
F. You can change the sequence of the alarms and the definition of each individual alarm in
this list by pressing F1 Edit.
G
. Press F10 Exit repeatedly until the main menu appears again.
Activating the Alarm System
The alarm system still has to be activated in the project definition. To change the project
definition, follow these steps:
1
. Access the project definition using option Project in the Edit menu, or by using key
combination Ctrl + P:
2
. Press function key F1 Project Def.
3
. Move the cursor to the line Enable Alarm System.
4
. Enter
Y
and confirm it by pressing ↵↵.
5
. End the project definition with F4 Accept.
6
. Close the project editor with F10 Exit. The main menu appears again.