Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
6 - 58 PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 GFK-1115
6
Editing the Alarm System
The alarm system can be accessed via the Alarm System option in the Edit menu, or by pressing
the key combination Ctrl + A. The alarm system basic configuration screen appears:
For the demo project, no printer will be supported. To disable the printer, follow these steps:
1
. Press F1 Edit to begin editing the Alarm System Basic Configuration.
2
. Move the cursor to the Printer Available field, type
NO
, and press ↵↵.
3
. Press F4 Accept to complete the editing step.
4
. Now press F4 Alarm Group List to call up a directory of alarm groups. By default, this
directory contains two predefined groups:
5. In order to display alarms from the PLC, which are stored in the Panel, an alarm group must
be inserted. To do this, follow these steps:
A
. Press F2 Ins. The Alarm Group Definition window appears: