Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
6 - 24 PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 GFK-1115
6
MAIN Picture (Main Menu)
No data from the PLC is shown in this picture.
The date and time are taken from the internal
real-time clock in the Panel.
Text is also displayed informing the user of the
function keys that can be used for switching to the
next pictures. Assigning the function keys to their
actual functions is done in the project editor.
To create this picture follow these steps:
1. Open the picture editor from the main menu with key combination Ctrl + B (see “Creating the
Pictures”).
2. Insert all lines and text in the rectangle so that it looks like the one below:
3. Move the cursor to position (21,0). The cursor position is indicated in the lower right-hand
corner of the window, as (column, row).
4. Insert a field for displaying the date and time:
● Press F2 Field.
● Select the entry Output Field from the Field Class selection window and then press the ↵
key.
● Select the Output Date/Time output field from the Select Field Type selection window.
The following window will appear: