Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
GFK-1115 Chapter 6 Demo Project 6 - 9
6
Value Entries
INPUT VALUES Picture
If you have pressed the F1 key in the main menu, the following picture appears on the screen:
Key LEDs:
9
8
7
4
5
1
6
2
0
3
EC
F1 F2 F3
+P+
+p+
F4
+N+
+n+
+G+
.
F5 F6 F7 F8
By pressing key F1/F2, the content of PLC address %R0001 is increased/decreased in steps:
F1 Increases the value by 1 initially, then at greater increments the longer the key is pressed
F2 Decreases the value by 1 initially, then at greater increments the longer the key is pressed
The contents of PLC address %R0002 can be changed by directly entering a value through the
keyboard numeric keys. Keys +p+ and +n+ switch between the two input fields.
The contents of the two PLC variables are displayed again in two output fields. The display is
defined with preceding zeros. Keys F3 and F4 are used to switch to one of the following pictures:
F3 Changes to the CLOCK picture
The date and time of the Panel can be entered/changed in this picture.
F4 Picture changes back to the main menu.