User's Manual

CAS GPS Node User Manual
CAS GPS User Manual (DOCU0097) A Page 7 of 24
5 Storage
Where the equipment is not to be installed immediately, proper storage is important to ensure protection of equipment and
validity of warranty.
All equipment should be stored indoors protected from the elements in a cool dry area. If storing on the ground,
ensure that the storage area is not an area where water will collect.
All equipment which contains batteries, must be placed in “Transit Mode” prior to storage. This mode disables the battery.
6 Unpacking of Equipment
The method of packing used will depend on the size and quantity of equipment.
7 Installation
Installation should be in accordance with the installation procedures defined by GE Mining. The installations must only be
performed by authorised and qualified installers.
8 Test & Commission
At installation time, the system must be checked against the installation test procedure (ITP) to verify the system is
correctly installed and functioning as required. After passing its final installation test, the system is then ready for
use after which inbuilt self- diagnostic testing combined with daily user monitoring ensures that any faults can be acted
upon.
Take care when unpacking the equipment to avoid damage.