User's Manual

CAS GPS Node User Manual
CAS GPS User Manual (DOCU0097) A Page 10 of 24
9.4.1.2 Suction Cup Installation of PDA Cradle In Vehicle
 Clean the mounting surface thoroughly. Ensure that the surface is completely dry and free of any dirt or residue. For
best results use rubbing alcohol or similar to clean the surface prior to installation.
 Determine placement of your suction cup by using the cradle as a guide.
 Once satisfied with the location for the suction cup, remove the cradle from the suction cup and push the suction
cup into place – the suction cup should hold in this position without any weight on it.
 Ensure the rotational alignment is correct.
 Push the locking lever towards the mounting surface to secure in place.
 Adjust the Up/Down and Left/Right Alignment of the cradle by releasing the adjustment screws and moving the
cradle with your hand.
 Ensure all adjustment screws are tight prior to fitting the PDA to the cradle.
Up / Down
Adjustment Screws
Locking Lever
Left / Right
Adjustment Screw
Cradle AdapterShort / Long
Swing Arms
9.4.1.3 Charge Cable for Portable Installation
The charge cable for the Portable Cradle is fixed to the cradle and needs to be plugged into a power outlet in the Light
Vehicle. There is a 2A replaceable fuse in the plug to protect the system.
To Vehicle Power
Outlet
9-30VDC
2A Blade Fuse