User's Manual

16
CAS GPS Installation Manual Rev G1
2/17/2016
Mounting Locations & Cable Runs
 Follow existing cable runs where possible
 All cables to be secured using P-Clamps where possible
 Cable ties should be used as a last resort where there is no provision for P-Clamps
Ensure cable ties are cut flush to avoid sharp edges
 Cables should be secured at a minimum every 300mm
 Avoid running cables near hot spots and pinch points
 Glands should be used on cables running through bulkheads
 It is recommended that a service loop be created on all the Antenna Coax Cables
this will especially aid in servicing of the system. i.e. Break in termination at either
end of the Coax cables.
 Service loops are acceptable in the Coax and Display cables. Ensure if a service
loop is placed in the Coax Antenna cable that it is placed in a position that it is not
going to create a hazard, also ensure the service loop radius is not to small.
 If mounting through a blind panel the supplied Nutserts should be used to enable
easy removal for servicing