User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 92 of 126
Issue: E
15.4.4 Operational Checks
• Drive past the Test Station (TS) and verify detection on the Dash Alarm unit (warble
tone) and roof mounted Rotating Beacon (if fitted - verify beacon operation using
Test Station mirror). The Test Station rotating beacon should also switch on when
the Mobile Plant & Equipment Unit enters the programmed Detection Zone.
15.4.5 Maintenance Requirements
Routine Checks
• Check that the antenna is securely screwed onto the Rotating Beacon Unit
enclosure and located in the upright position. Tighten and straighten by hand if
necessary (secure using Loctite 243).
• Check the operation of rotating beacon and dash alarm at the Test Station (TS).
• Check all equipment and cabling is secure. Re-secure if necessary.