User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 91 of 126
Issue: E
15.3 Stationary Object (SO) Unit
15.3.1 Operational Care
• To avoid electrical shock, do not open the electrical equipment enclosures. There
are no user serviceable parts located inside the equipment items.
15.3.2 Maintenance Requirements
Monthly Checks
• Check that the antenna is securely screwed onto the Rotating Beacon Unit
enclosure and located in the upright position. Tighten and straighten by hand if
necessary (secure using Loctite 243).
• Check the operation of the Rotating Beacon by triggering a detection using a Heavy
Vehicle (in gear) or the Test Station (TS).
• Check all equipment and cabling is secure. Re-secure if necessary.
15.4 Mobile Plant & Equipment (HV) System
15.4.1 Operational Care
• To prevent fire or shock hazard, do not expose the Dash Alarm Unit to rain or
moisture.
• To avoid electrical shock, do not open the electrical equipment enclosures. There
are no user serviceable parts located inside the equipment items.
• The audible alarm contained within the Dash Alarm Unit must not be blocked with
foreign objects in order to reduce alarm sound levels as this is the primary means of
notifying drivers of potential collisions. Consult the AMT Service Agent if you wish to
adjust the alarm sound levels to suit the ambient noise levels of the particular
installation.
• The visual alarm contained on the Dash Alarm Unit should not be covered over with
foreign objects in order to reduce night vision glare as this is the secondary means
of notifying drivers of potential collisions (the primary means being the audible
alarms). The intensity of the led indicators (alarm and power) have been set at low
intensity levels suited for both day and night visibility.
15.4.2 Pre-Operation Inspection
External Checks
• Visually check that the roof mounted Rotating Beacon (if fitted) or RF Unit and
wiring harness are secure.
• Check that the antenna is securely screwed onto the Rotating Beacon enclosure
and located in the upright position. Tighten and straighten by hand if necessary
(secure using Loctite 243).
15.4.3 Startup Inspection
• Check that the dash alarm power indicator is ON