User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 74 of 126
Issue: E
10.2.1.4 Alarm Specifications
Alarm Conditions: HV (in gear) or TS detected within LV programmed Detection Zone
Alarm Zones: Single programmable Detection Zone
Alarm Output: Flashing beacon on roof (optional), dash-mount audible alarm and
flashing alarm indicator
Alarm Tones: High rate pulsed tone on initial HV (in gear) or TS detection,
changes after 3 seconds to low rate pulsed tone upon continuous
HV or TS detection.
Reverts back to high rate pulsed tone when either HV changes gear
or another HV or TS is detected.
Alarm Cancellation: HV or TS outside of LV Detection Zone (or HV out of gear)
Table 38: Light Vehicle Alarm Specifications
10.2.2 Power On/Off
The Light Vehicle Unit is permanently powered ON and will only generate alarms when a
HV (in gear) or TS is detected within the LV Detection Zone.