User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 69 of 126
Issue: E
Auto Cycling is paused when either the operator manually selects a camera or automatic
camera switching is activated on gear changes or with RF front / rear detections. Press the
‘CYCLE’ key to resume Auto Cycling.
Disabling Auto Cycling
Disabling the Auto Cycle function is only programmable at the time of installation using a
laptop PC. This function setting is saved during power down and is automatically restored
at power on.
10.1.8 DIM Function
The DIM function provides 5 levels of global Brightness settings for all cameras.
Press the ‘DIM’ key to scroll thru 5 levels of Brightness settings from minimum to
maximum and then back to minimum.
10.1.9 Display Reset Function
Pressing simultaneously the keys ∎ and ● will generate a Display Reset which causes
the Display to Reboot. When reset, the message RESETTING’ will be displayed on the
screen before switching to the Boot-Up screen (refer to section 11.1). This function should
only be used in the event of a screen or keypad lockup and should be reported to the AMT
Service Agent.
10.1.10 Recording Video Signals (PAL format)
A VCR unit with PAL format can be connected to the ‘VIDEO OUT’ connector on the rear
panel of the Display Unit for recording the video images along with text alarms and
messages.
The video signal can also be displayed on an external monitor if desired using the same
‘VIDEO OUT’ connector.
NOTE: for camera channels in mirror mode (horizontal flip), the text will appear mirrored
(i.e. backwards) on the ‘VIDEO OUT’ signal.