User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 123 of 126
Issue: E
22 WARRANTY INFORMATION
22.1 Warranty
Subject to the AMT General Terms and Conditions, all new equipment supplied and
commissioned by AMT (or approved Service Agent) is warranted against defects for a
period of twelve (12) months from completion of commissioning.
The obligation of AMT is limited to the cost of making good the defect in the equipment
only and specifically excludes any consequential malfunction or loss, including loss of
profits or turnover.
This warranty does not apply to defects incurred through improper field installation, expiry
of consumable items, abnormal operating conditions, accidental damage, improper
handling, abuse or neglect or non-compliance with instructions provided by AMT.
The warranty is valid for the customer only and does not extend to third parties.
AMT will, at no charge to the customer, provide a replacement for any defective
component in the equipment supplied by AMT during the warranty period. However, labour
charges for dismantling and re-assembly shall be to the customer’s account.
AMT takes no responsibility for defects in the equipment, or part of the equipment, caused
in connection with the above-mentioned replacement work if performed by other than AMT
or their accredited representative(s).
Normal system testing and calibration may only be carried out by trained customer
technical personnel or accredited Service Agent(s) using the techniques provided by AMT.
22.2 Maintenance and Repairs
AMT will provide warranty coverage against equipment defects for a period of twelve (12)
months from completion of commissioning as outlined above.
If the customer is purchasing spares of each major equipment item, trained customer
technical personnel or accredited Service Agent(s) could replace defective equipment
items with working spare equipment items to immediately restore full equipment operation.
The defective equipment items would be returned via courier to AMT for immediate repair
and subsequent return to the customer. Refer to section 17 for the preferred ‘Fault
Reporting’ procedure.