User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 12 of 126
Issue: E
primary means of notifying drivers of potential collisions. Consult the AMT Service
Agent if you wish to adjust the alarm sound levels to suit the ambient noise levels of
the particular installation. Additionally for the above reason, the Light Vehicle Dash
Alarm Unit and Mobile Plant & Equipment Dash Alarm Unit must not be
disconnected during normal operation.
• The visual alarms contained on the Heavy Vehicle Display Unit Screen, Light
Vehicle Dash Alarm Unit and Mobile Plant & Equipment Dash Alarm Unit should not
be covered over with foreign objects in order to reduce night vision glare, as this is
the secondary means of notifying drivers of potential collisions (the primary means
being the audible alarms). The brightness level can be switched to a low setting on
the Heavy Vehicle Display Unit Screen by activating ‘DIM’ mode (refer to section
10.1.8). The intensity of the Power On LED indicators on both equipment items and
the Light Vehicle Dash Alarm Unit and Mobile Plant & Equipment Dash Alarm Unit
‘alarm’ LED indicators have been set at low intensity levels suited for both day and
night visibility.
• This equipment generates random low power radio frequency emissions (license
exempt) for automatic object detection using RF tagging (CAS-RF
®
) and could
interfere with existing radio communication devices even though classified as a
‘Low Interference Potential Device’ (LIPD). If this is the case, contact the AMT
Service Agent for further investigation. Operating frequencies may need to be
changed to cater for existing radio communication spectrum usage for the particular
application. Similarly, the CAS-RF
®
equipment may not be immune to interference
by other higher power radio communication devices present on site.
1.3 Installation
• Only AMT Service Agents are to carry out installations. Non-approved installations
will automatically void the warranty conditions.
1.4 Repairs
• Only AMT Service Agents are to carry out repairs. Non-approved repairs will
automatically void the warranty conditions.
• Do not remove equipment item covers. There are no user serviceable parts located
inside the equipment items.