User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 105 of 126
Issue: E
16.3.6 Test Station (TS) Diagnostic Table
Symptom Possible Cause Corrective Action
TEST STATION (TS)
Unit
Rotating Beacon not
connected
Check connections
Loss of power Check power supply (permanent, battery,
solar etc)
HV Not in Gear Check HV gear status
Loss of Detection
Zone settings
Unit should still work with factory default
Detection Zone settings (30 m range)
Contact Service Agent
Poor Antenna
Connection
Check antenna is firmly attached &
orientated upright.
Check for antenna damage & replace if
necessary – contact Service Agent.
Blown lamp Replace lamp (12V, 55W)
Warning: isolate power from the beacon
by disconnecting the external connector
before removing the lamp cover in order
to replace a globe, as the beacon may
start revolving without warning when any
tagged object is within the TS Detection
Zone.
Faulty internal drive Replace with Spare Unit
Contact Service Agent for repair
No TS Rotating Beacon
Alarm when within the
Detection Zone of other
tagged objects (i.e. HV,
LV, SO, PT)
Faulty Tagged
Object
• HV (refer to Troubleshooting section
16.3.1)
• LV (refer to Troubleshooting section
16.3.2)
• SO (refer to Troubleshooting section
16.3.3)
• PT (refer to Troubleshooting section
16.3.5)
No TS Detections by
tagged objects when
within the TS Detection
Zone
Faulty Unit Replace with Spare Unit
Contact Service Agent for repair
External Beacon not
rotating but lamp is ON
“All of above” “All of above”
External Beacon
rotating but lamp is OFF
Faulty internal drive Replace with Spare Unit
Contact Service Agent for repair
Blown lamp Replace lamp (12V, 55W)
Warning: isolate power from the beacon
by disconnecting the external connector
before removing the lamp cover in order
to replace a globe, as the beacon may
start revolving without warning when any
tagged object is within the TS Detection
Zone.