User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 101 of 126
Issue: E
16.3.3 Stationary Object (SO) Diagnostic Table
Symptom Possible Cause Corrective Action
STATIONARY OBJECT
(SO) Unit
Rotating Beacon not
connected
Check connections
Loss of power Check power supply
(permanent, battery, solar etc)
Loss of Detection Zone
settings
Unit should still work with
factory default Detection Zone
settings (30 m range)
Contact Service Agent
HV not in gear Check HV gear status
Poor Antenna Connection Check antenna is firmly
attached & orientated upright.
Check for antenna damage &
replace if necessary – contact
Service Agent.
Blown lamp Replace lamp (12V, 55W)
Warning: isolate power from the
beacon by disconnecting the
external connector before
removing the lamp cover in
order to replace a globe, as the
beacon may start revolving
without warning when a Heavy
Vehicle is within the SO
Detection Zone.
No external Rotating
Beacon Alarm when within
HV (in gear) or TS
Detection Zone.
Faulty internal drive Replace with Spare Unit
Contact Service Agent for repair
No SO Detections by HV
(in gear) or TS when within
the SO Detection Zone
Faulty Unit Replace with Spare Unit
Contact Service Agent for repair
External Beacon not
rotating but lamp is ON
“All of above” “All of above”
External Beacon rotating
but lamp is OFF
Faulty internal drive Replace with Spare Unit
Contact Service Agent for repair
Blown lamp Replace lamp (12V, 55W)
Warning: isolate power from the
beacon by disconnecting the
external connector before
removing the lamp cover in
order to replace a globe, as the
beacon may start revolving
without warning when a Heavy
Vehicle is within the SO
Detection Zone.