Safety Manual

Electromagnetic Compatibility (EMC)
5
Electromagnetic Compatibility (EMC)
Before installing or using the device or system, be aware of the proximity of known
radio frequency (RF) sources, such as the following:
• Radio and TV stations
• Portable and mobile RF communication devices (cell phones, two-way radios)
• X-ray, CT, or MRI devices
These devices are also possible sources of interference as they may emit higher
levels of electromagnetic radiation.
WARNING:
EQUIPMENT MALFUNCTION
Use of this equipment adjacent to or stacked with other equipment should be
avoided because it could result in improper operation. If such use is necessary, this
equipment and the other equipment should be observed to verify that they are
operating normally.Portable RF communications equipment (including peripherals
such as antenna cables and external antennas) should be used no closer than 30
cm (12 inches) to any part of the [ME EQUIPMENT or ME SYSTEM], including cables
specified by the manufacturer. Otherwise, degradation of the performance of this
equipment could result.
WARNING:
EQUIPMENT MALFUNCTION OR INTERFERENCE
Use of this equipment adjacent to or stacked with other equipment should be
avoided because it could result in improper operation. If such use is necessary, this
equipment and the other equipment should be observed to verify that they are
operating normally.
WARNING:
PATIENT SAFETY/EQUIPMENT FAILURE
Use of accessories, transducers and cables other than those specified or provided
by the manufacturer of this equipment could result in increased electromagnetic
emissions or decreased electromagnetic immunity of this equipment and result in
improper operation.
2109599-003 A MAC
™
7 Resting ECG Analysis System 23