User Manual

8 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions Revision A - Draft 7
2001989-135
Introduction
Overview
The programming device can be used to perform these functions:
 Program the transmitter’s basic functions.
 View the transmitter’s firmware code version numbers and diagnostic
test results.
 Replace a transmitter’s PCB (by trained service personnel only.)
 Generate reports for transmitters that have been programmed.
 (ApexPro and ApexPro CH) Update the firmware code.
 (ApexPro) Set the transmitter’s feature level.
 Perform troubleshooting.
When you are done programming transmitters, disconnect the transmitter
from the programming device and remove the batteries from the transmitter.
(See page 12).
If you have problems at any time, refer to the troubleshooting section for
your specific transmitter.
Standards Used in this Manual
Definitions
The following methods are used in this manual to describe various features
and functions.
Button or LED label — The name of a specific LED or a physical button
located on the transmitter or the programming device. Press to perform a
function. In this manual, a button is shown in bold (for example, RA, LL,
Graph, etc.)
Screen text — Any text that appears on the PC display for the software. In
this manual, screen text is shown in italics (for example, TTX Number, OK,
etc.).
Illustrations and Names
All illustrations in this manual are provided as examples only. They may not
necessarily reflect your specific setup or the data displayed on your PC.
In this manual, all names appearing in examples and illustrations are
fictitious. The use of any real person’s name is purely coincidental.
Document Revision History
Each page of this document has the document part number and revision
letter at the bottom of the page. The revision letter changes whenever the
document is updated.
Rev. Date Comments
A 04 August 2003 Initial release of this document for software version 2A.
Draft