User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Apex Transmitter
- 3 ApexPro CH Transmitter
- Program the Transmitter’s Basic Functions
- View Transmitter Diagnostics
- Update Transmitter Firmware
- ApexPro CH Appendices
- 4 ApexPro Transmitter
Revision A - Draft 7 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions 43
2001989-135
ApexPro CH Transmitter
3. Select the Download EEPROM Code button. The message shown below
will display.
NOTE
NOTENOTE
NOTE
If the above message does not display, you must manually reset the
program as instructed in “Reset the Transmitter Manually” on page 51.
4. Using a small pointed device (such as the tip of a pen) press in and hold
the Clear Transmitter Memory button in the side of the Apex
programming device. Another window will display after approximately 4
seconds. Or select Cancel to stop the download process and return to the
Super User window.
5. Select the type of file to update and select OK.
386A
387A
Draft