User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Apex Transmitter
- 3 ApexPro CH Transmitter
- Program the Transmitter’s Basic Functions
- View Transmitter Diagnostics
- Update Transmitter Firmware
- ApexPro CH Appendices
- 4 ApexPro Transmitter
Revision A - Draft 7 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions 11
2001989-135
Introduction
Run the Installation Wizard
1. Close all open applications on the PC.
2. Insert the configuration software CD into the CD drive.
3. Run the “Setup.exe” file from the CD.
4. Follow the on-screen instructions.
Connect the Hardware
1. Connect the 9-pin serial cable to the transmitter programming device.
On your PC, the port might be labeled “1” or “2”. If so, make a note of this
for later identifying the COM port used when running the software.
NOTE
NOTENOTE
NOTE
If the PC does not have a serial port, install USB-to-serial cable/adapter
(PN 2015891-001) and configure it using its accompanying software.
2. Replace the transmitter batteries with two new AA alkaline batteries.
3. Remove the transmitter’s leadwire set and the interface connector port
dust covers.
PC
Programming Device
Draft