User Manual Part 5

Equipment setup
2001989-301A- draft 1 ApexPro™ 3-7
Optional components
Xpod oximeter
CAUTION
Use only Nonin SpO2 probes with the oximeter. The reliability of
SpO2 data obtained with any other probe has not been verified.
The Xpod oximeter uses the battery power supplied by the transmitter. Connect the
oximeter to the INTFC connector (labeled 1 on its dust cover) on the transmitter and
to the Nonin SpO2 probe. Once connected, follow your unit’s protocol for attaching
the transmitter and the oximeter to the patient.
428A
Apex oximeter
CAUTION
Use only Nonin SpO2 probes with the Apex oximeter. The
reliability of SpO2 data obtained with any other probe has not been
verified.
400C
The perfusion LED indicates the strength of the patient’s SpO2 signal.
To turn the digital display on or off at any time, press the Display On/Off button. To
turn the display on continuously, press and hold the Display On/Off button for 2
seconds. The flashing Power LED turns off.
Power
Display
On/Off
Pulse Rate
SpO %
2
Perfusion
o x ime ter
Draft