User's Manual

WMTS TRANSCEIVERS
184 PatientNet Operator’s Manual, v1.04, 10001001-003, Revision B
All information contained herein is subject to the rights and restrictions on the title page.
Displaying Transceiver Status
You can view transceiver status on the Central Station, but not on the PatientNet
Viewers (also known as the IRVS and RVS).
1. Press System on the Main screen.
2. Press OpenNet button on the Passcode screen to display the OpenNet Status
screen (fig. 90).
Fig. 90. OpenNet Status screen
Your System Administrator enables or disables the Assign TX, Program AT, and
Program IT buttons. Check with your System Administrator for more information.
The columns in the OpenNet Status screen are described below.
Ch
channel number
Module ID
Transceiver ID that the channel is currently set to
Device ID
Device ID of the transceiver from which the channel receives data
Batt
battery voltage of the ambulatory transceiver
LL
left leg electrode impedance value
RA
right arm electrode impedance value
LA
left arm electrode impedance
Va
chest electrode impedance value
Vb, Vc
miscellaneous electrode impedance value
Freq Resp
frequency response programmed into each transceiver
Link
link between the transceiver and the Central Station:
OK: the Central Station is receiving data from the transceiver
OFF: the Central Station is not receiving data
Device
Type
transceiver or bedside monitor associated with the channel
Version TX
the download firmware version currently in the transceiver
Version RX
the RF Module firmware version currently in the transceiver
Ch
channel number