User's Manual
Table Of Contents
- WMTS Transceivers
- About Transceivers
- Programming Transceivers
- Displaying Transceiver Status
- User Warnings, Cautions, and Notes
- Ambulatory Transceiver (DT-4500)
- Operating Instructions
- Push Button Function and Use
- LED Indicators Function
- Cleaning
- Cleaning the Chassis
- Cleaning the Battery Compartment
- Cleaning the ECG Leadsets
- Use and Maintenance
- Transceiver Storage
- Attaching and Removing a Leadset from the Transcei...
- Internal Antenna
- Installing and Removing a Battery
- Warnings
- Cautions
- Instrument Transceiver (DT-7000, DT-7001)
WMTS TRANSCEIVERS
192 PatientNet Operator’s Manual, v1.04, 10001001-003, Revision B
All information contained herein is subject to the rights and restrictions on the title page.
The Quality Threshold value has a default setting. If the electrode’s impedance value
is greater than the default, then its LED is illuminated. The DT-4500 stores the Quality
Threshold value and uses this value to determine whether or not the electrode LED
should be illuminated when the Attendant Present buttons are pressed.
See “Impedance Values” on page 185 for details.
Note: The V6 indicator will be available in future releases; therefore, the V6 LED
will not illuminate when the Attendant Present buttons are pressed.