User's Manual

MDS 05-6302A01, Rev. B MDS Mercury 16E Technical Manual 63
Port Status (LAN)
LAN1/2 Port Enable LAN is enabled/disabled. Note that
LAN2 only applies to BS/SU indoor
units (IDUs).
Enabled
Enabled, Disabled
LAN1/2 Port Phy Rate Speed/Duplex of LAN port.
Over-the-air link status depends on
Base Station’s LAN connection. Note
that LAN2 only applies to BS/SU indoor
units (IDUs).
Auto
10 MB, Half Duplex
10 MB, Full Duplex
100 MB, Half Duplex
100 MB, Full Duplex
LAN 1/2 Port Follows
Association (SU only)
If enabled, SU’s LAN port functions
depending on its associated status.
Disabled
Enabled, Disabled
LAN1/2 Port Phy
Status
Read-only indication of whether port is
connected or not connected.
--
LAN1 Filtering
Enable LAN1 Filtering Turns on LAN filtering. Disabled
Enabled, Disabled
LAN1 Address 1-8 Turns on LAN filtering. 0.0.0.0
Valid IP address
LAN2 Filtering (IDU BS/SU only)
Enable LAN2 Filtering Turns on LAN filtering. Disabled
Enabled, Disabled
LAN2 Address 1-8 Turns on LAN filtering. Valid LAN 2 address
802.11 (units with Wi-Fi only)
802.11 Mode Configures the Wi-Fi radio to be an
Access Point for other Wi-Fi devices
(Access Point), to connect to a Wi-Fi
Access Point at another location
(Station), to connect directly to another
Wi-Fi device (Ad-Hoc), or to be
disabled (disabled).
Disabled
Access Point, Station,
Ad-Hoc, Disabled
802.11 SSID Service Set Identifier, the name of the
wireless LAN to which to connect. This
is equivalent to Network Name in GE
MDS terminology.
40-character string
Broadcast 802.11
SSID
When enabled, the SSID of the Wi-Fi
Access Point is broadcast over the air
so that stations will detect the APs
presence.
Enabled
Enabled, Disabled
802.11 Channel (Applies only when 802.11 Mode is set
to Access Point or Ad-Hoc). Sets the
802.11 channel the device will use.
Channel 6
Ch. 1-11 (N. America)
Ch. 1-14 (Japan)
Ch. 1-13 (other regions)
802.11 Station
Timeout (AP only)
Determines how quickly inactive
stations are “aged out” of the Wi-Fi
Access Point’s database.
2 minutes
1 to 240 minutes
Table 17. Configuration Parameters (Continued)
Menu Location Parameter Name Description Default Value
Possible Values