User's Manual

MDS 05-3627A01, Rev. D LEDR Series I/O Guide 45
Table 15. NMS Commands
Command Description Summary Details
? or help Displays the available NMS commands. May also
be entered after any other command to obtain
context sensitive help.
Page 48
ais Echoes/enables/disables Alarm Indication Signal
(AIS) generation and Remote Alarm Indication
(RAI) detection, AIS and RAI Signal (RAIS)
forwarding on given span(s).
Page 49
alarm Provides control of alarm outputs and displays
state of alarm inputs.
Page 50
alert Sends an alert sound to the specified radio
Page 51
arp Set/display ARP Setting of Ethernet Port
Page 51
ber Bit-Error Rate report for the RF link.
Page 52
bert Bit-Error Rate test of data interface
Page 52
boot Displays the active image (firmware) or reboots
the radio with a specified firmware image
Page 54
buzzer Briefly sounds the radio’s piezo buzzer to test its
operation
Page 54
clkmode Set/display data clocking mode
Page 55
coffset Displays modem carrier frequency offset in Hz
Page 56
con Set/display CONSOLE Port communications
parameters
Page 56
config Used to get or send a radio configuration file
Page 56
date Set/display current date
Page 57
dtmf Turns dual tone, multi-function signaling feature
on or off
Page 57
eia530 Set/display EIA-530 RTS or DTR control lines
Page 57
ethernet Displays Ethernet address
Page 57
events Event log commands
Page 57
evmap Set/display alarm port and alarm LED settings
Page 58
fec Display corrected and Uncorrectable FEC errors
Page 58
freq Set/display operating frequencies
Page 59
fset Display absolute frequency limits
Page 59
fstruct Set/display current span(s) frame structure
Page 59
g821 Show/Reset G.821 information
Page 60
group Set/display network group
Page 60
help or ? Displays the available NMS commands. May also
be entered after any other command to obtain
context sensitive help.
Page 48