User's Manual

ManualsBrandsGE MDS ManualsElectronicsDigital Radio

Table Of Contents

40 LEDR Series I/O Guide MDS 05-3627A01, Rev. D

Orderwire

This menu allows you to “ring” the Orderwire at a specified radio site.

Refer to USING ORDERWIRE on Page 99 for instructions on using the

Orderwire.

This screen is used to set or display the Orderwire volume. Use the

keys to adjust the volume level. Pressing

saves the adjusted

value as the default setting.

This screen is used to set or display the Orderwire vox threshold (acti-

vation level). Use the keys to adjust the vox threshold. Pressing

saves the adjusted value as the default setting.

Performance

The Performance menu items provide diagnostics information regarding

the radio. The following diagnostic parameters are available on a con-

tinuous, updating basis:

• RSSI—Received Signal Strength Indicator

• SNR—Signal/Noise Ratio (not valid if there is an RX Alarm)

• POUT—Power Output

• PA Temperature—Power amplifier temperature

The RSSI display indicates the strength of the radio signal being

received by the radio. The measurement is in dBm. Therefore, an RSSI

of –80 dBm is stronger than a –100 dBm signal.

The SNR display indicates the relationship of the amount of intelligence

versus noise on the radio signal. The higher the SNR, the better the

quality of the radio signal.

For the NMS command-line

equivalent,

see “alert” on

Page 51

ENTER

For the NMS command-line

equivalent,

see “volume”

on Page 88

ENTER

For the NMS command-line

equivalent,

see “vox” on

Page 88

For the NMS command-line

equivalent,

see “rssi” on

Page 79

For the NMS command-line

equivalent,

see “snr” on

Page 81