User's Manual
Table Of Contents
- 1.0 INTRODUCTION
- 2.0 MODEL NUMBER CODES
- 3.0 HARDWARE INSTALLATION AND BASIC INTERFACE REQUIREMENTS
- 4.0 INITIAL STARTUP AND CONFIGURATION
- 4.1 Introduction
- 4.2 STEP 1—Power up the LEDR Radios
- 4.3 STEP 2—Establish Communications with the Radio
- 4.4 STEP 3—Make Initial Login to Radio
- 4.5 STEP 4—Change the SUPER Password
- 4.6 STEP 5—Review Essential Operating Parameters
- 4.7 STEP 6—Set TCP/IP Settings to Enable SNMP and/or Telnet Management (if required)
- 4.8 STEP 7—Set User Configurable Fields
- 4.9 STEP 8—Verify Radio Performance
- 4.10 STEP 9—Install the Link
- 4.11 STEP 10—Verify the Link Performance
- 5.0 CONFIGURATION AND CONTROL VIA THE FRONT PANEL
- 6.0 CONFIGURATIONAND CONTROL VIA THE CONSOLE PORT
- 7.0 STANDARDIZING RADIO CONFIGURATIONS
- 8.0 UPGRADING LEDR FIRMWARE
- 9.0 USING ORDERWIRE
- 10.0 USING THE SERVICE CHANNEL
- 11.0 PROTECTED CONFIGURATION
- 12.0 SPACE DIVERSITY OPERATION
- 13.0 SPARE PARTS, UNITS AND ACCESSORIES
- 14.0 Fractional-T1 INTERFACE CARD 03-3846A01 Fractional-E1 INTERFACE CARD 03-3846A02
- 15.0 INCREASE BANDWIDTH BY CHANGING TRANSMITTER AND RECEIVER FILTERS
- 16.0 BENCH TESTING OF RADIOS
- 17.0 TECHNICAL REFERENCE
- 17.1 Specifications— Models: LEDR 400S, 700S, 900S and1400S
- 17.2 Specifications— Models: LEDR 400F, 900F, 1400F
- 17.3 Specifications— Protected Switch Chassis
- 17.4 Optional Equipment (Consult factory for detailed information)
- 17.5 Accessories
- 17.6 I/O Connector Pinout Information
- 17.7 Watts-dBm-Volts Conversion
- 18.0 RADIO EVENT CODES
- 19.0 IN CASE OF DIFFICULTY
ii LEDR Series I/O Guide MDS 05-3627A01, Rev. D
4.2 STEP 1—Power up the LEDR Radios .........................................................................................25
4.3 STEP 2—Establish Communications with the Radio ..................................................................26
4.4 STEP 3—Make Initial Login to Radio ..........................................................................................26
4.5 STEP 4—Change the SUPER Password ....................................................................................27
4.6 STEP 5—Review Essential Operating Parameters .....................................................................28
4.7 STEP 6—Set TCP/IP Settings to Enable SNMP and/or Telnet Management (if required) ..........29
4.8 STEP 7—Set User Configurable Fields .......................................................................................29
4.9 STEP 8—Verify Radio Performance ............................................................................................29
4.10 STEP 9—Install the Link ...........................................................................................................29
4.11 STEP 10—Verify the Link Performance ....................................................................................29
5.0 CONFIGURATION AND CONTROL VIA THE FRONT PANEL...........................................29
5.1 Front Panel LCD Menu Descriptions ...........................................................................................32
CONSOLE .....................................................................................................................................32
Default Screen ...............................................................................................................................32
Diagnostics ....................................................................................................................................32
Front Panel.....................................................................................................................................33
G.821 .............................................................................................................................................33
General ..........................................................................................................................................34
IO Configuration.............................................................................................................................35
Line Configuration..........................................................................................................................36
Login ..............................................................................................................................................38
Logout............................................................................................................................................38
Modem...........................................................................................................................................38
Network..........................................................................................................................................39
Orderwire .......................................................................................................................................40
Performance...................................................................................................................................40
Redundant .....................................................................................................................................41
Remote Status ...............................................................................................................................42
RF Configuration............................................................................................................................42
6.0 CONFIGURATION AND CONTROL VIA THE CONSOLE PORT ......................................43
6.1 Introduction ..................................................................................................................................43
6.2 Initial Connection to the CONSOLE Port .....................................................................................44
6.3 NMS Commands .........................................................................................................................44
Command Entry Hints—Recalling Commands..............................................................................44
6.4 Command Detailed Descriptions .................................................................................................48
Introduction ....................................................................................................................................48
6.5 Disabling the Front Panel Alarm LED for Unused E1 Option Ports .............................................88
7.0 STANDARDIZING RADIO CONFIGURATIONS..................................................................90
7.1 Introduction ..................................................................................................................................90
7.2 Setup by TFTP .............................................................................................................................91
Finding IP Addresses.....................................................................................................................91
Downloading Procedure.................................................................................................................91
Uploading Procedure .....................................................................................................................91
7.3 Setup Through the DB-9 CONSOLE Port ...................................................................................92