User's Manual

16 LEDR Series I/O Guide MDS 05-3627A01, Rev. D
The left and right arrow keys move the cursor in the corre-
sponding direction. When the cursor is below the character you
wish to change, press
. The arrow keys are then used to step
though the character set, beginning with numbers, then upper-
case letters and finally lowercase letters. Each time you press
one of the arrow keys, the display will step to the next character.
If you press and hold the arrow key for several seconds, the char-
acters will scroll by very quickly.
After you have built the string of characters you need, press the
key to save the string on the display and return to cursor
navigation mode. To save all changes you have made, place the
cursor under the special carriage return symbol ( ) and press
. Pressing will revert the arrow keys to the cursor nav-
igation mode. Pressing in cursor navigation mode cancels
character edit mode without saving any changes.
2. Scrolling Lists/Values— Uses left and right keys ( ) to
scroll through a list of choices or adjust a numeric value, such as
PP
PP
oo
oo
ww
ww
ee
ee
rr
rr
OO
OO
uu
uu
tt
tt
. When you are in a menu with a series of fixed parame-
ters, the vertical scroll character ( ) will appear while you are in
the editing/selection mode. If you are asked to select or change
more than one character, you will see a horizontal scroll symbol
( ) in the bottom right-hand corner of the display and a cursor
will appear under the character being edited or changed.
When the desired parameter is in view, move the cursor to the
right as far as it will go, until a carriage return symbol ( )
appears. Pressing the
key will save the selection to its left,
if your access privileges permit. Pressing cancels the selec-
tion and exits without saving the change.
3. Slider Bar Adjustment—Some menus display a horizontal
bar that changes its length to indicate the level for parameters
that use relative values such as the Orderwire Volume and VOX
threshold. (See Orderwire on Page 40.) Press the key to
increase the value and the to lower the value. Press
to
save the current setting.
Connectors
The front panel of the LEDR radio (Figure 10) has two connectors; both
of them are located on the lefthand side of the panel.
Orderwire The RJ-11 jack with the telephone symbol above it is to connect an
orderwire handset. The orderwire is used by service personnel to com-
municate through the Service Channel to coordinate system activities
with personnel at another site in the network. The orderwire will not
interrupt the normal data flow through the LEDR data communication
ENTER
ENTER
ENTER ESCAPE
ESCAPE
ENTER
ESCAPE
ENTER