User's Manual

05-4819A01, Rev. 08 LCT 450 Installation/Operation Guide

INSTALLATION

There are three main requirements for installing the transceiver as fol-

lows:

• Adequate and stable primary power

• An efficient and properly installed antenna system

• Correct data connections between the transceiver and the data

equipment.

Figure 4 shows a typical station arrangement. This is followed by

step-by-step procedures for installing the transceiver and making front

and rear panel connections.

Figure 4. Typical Station Arrangement

INTEGRATED PROCESSING

MODULE (IPM)

ANTENNA

SYSTEM

LOW-LOSS

COAXIAL CABLE

(50 Ohm)

RADIO

TRANSCEIVER

PL-259 UHF

CONNECTOR

DB-25M

CONNECTOR

Antenna Connector

DC POWER CABLE

Negative Ground

13.6 Vdc +/-15%