User's Manual

05-4819A01, Rev. 08 LCT 450 Installation/Operation Guide 13
OWM [XXX...]
Owner's Message
This is a command to display or program an owner's message. To pro-
gram the owner's message, type
OWM then the message, followed by
an ENTER keypress.
To display the owner's message, type
OWM, followed by an ENTER
keypress. The owner's message appears on the display.
OWN [XXX...]
Owner's Name
This is a command to display or program an owner's name. To pro-
gram the owner's name, type
OWN then the name, followed by
ENTER.
To display the owner's name, type
OWN then ENTER. The owner's
name appears on the display.
PROG
Program
The
PROG command used for serial reprogramming - spoof entry into
the bootloader.
PROGRAM
Program
The
PROGRAM command spoofing MDS x710 bootloader program
command to start serial reprogramming. Erases and programs inactive
image via serial port with xon/xoff flow control. Returns when com-
plete. If successful active image is switched. Only valid after program
or prog command at
LOADER> prompt. Used for serial reprogram-
ming.
PWRL [0-30], PWRM [0-30], PWRH [0-30],
PWRXH [0-30]
Sets Power Level
This command sets the power level value for this name. This name is
used for the power calibration command (CPWR). PWRL defaults to
5 watts, PWRM defaults to 20, PWRH is 25 and PWRXH is 30 watts.