User's Manual

12 LCT 450 Installation/Operation Guide 05-4819A01, Rev. 08
INIT
Initialize EEPROM Defaults
The INIT command is used to re-initialize the radio's operating param-
eters to the factory defaults. This may be helpful when trying to
resolve configuration problems that may have resulted from the entry
of one or more improper command settings. If you are unsure of which
command setting may have caused the problem, this command allows
you to get back to a known working state. The following changes to
the radio are made when
INIT is entered:
•
CTS is set to 0
• DATAKEY is set to ON
• DEVICE is set to DCE
• PTT is set to 0
• SCD is set to 0
• TOT is set to 30 seconds and set to ON
• PWR is set to +37 dBm (5 watts)
All other commands remain as previously set.
MODE [NORMAL, TEST]
Radio Mode
This command puts the radio into a
TEST or NORMAL mode. In the test
mode, it disables the radio from looking at the hardware channel select
lines and automatically selects Channel 0.
MODEL, MODEL1, MODEL2
Model Number Information
MTYPE [SD | X710_AE | X710_B | LOOPBACK]
Modem Family Type
OPT, OPTION, OPTIONS
Display Authorized Options