User's Manual

84 MDS iNET 900 Series User’s Guide MDS 05-2806A01, Rev. E.1
• Scanning—The unit is looking for an Access Point beacon
signal.
• Exp(ecting) Sync(hronization)—The unit has found a valid
beacon signal for its network.
• Hop Sync—The unit has changed its frequency hopping pat-
tern to match that of the Access Point.
• Associated —This unit has successfully synchronized and
associated with an Access Point. This is the normal status.
• Alarmed—The unit is has detected one or more alarms that
have not been cleared.
•
Current AP Mac Address—Wireless address of Access Point with
which the Remote is associated.
•
Current AP IP Address—IP address of Access Point with which
the Remote is associated.
•
Association Date—Date of last successful association with an
Access Point.
•
Association Time—Time of day association was established on
the association date.
•
Latest AP Firmware Version—
• AP Auto Upgrade—
• AP Reboot when Upgraded—
Remote Listing Menu
(Access Points Only)
Figure 3-47. Remote Listing Menu
(List of transceivers associated with this AP)
• MAC Address—Hardware address of the Remote transceiver.
• IP Address—IP Address of the Remote transceiver.
• State—Current association state of the Remote transceiver.
• AgeTime—Time, in minutes, remaining before the device (address)
will be deleted from the table.