User's Manual

24 MDS iNET 900 Series User’s Guide MDS 05-2806A01, Rev. E.1
If the radio network seems to be operating properly based on observa-
tion of the unit’s LEDs, you can use the
PING command to verify the link
integrity with the Access Point or pointing your browser to another
Remote unit’s IP address in the same network.
LINK
(Access Point)
ON Default state
Blinking Data Tx/Rx
OFF Traffic exceeds the capacity of
the radio network
LINK
(Remote
Gateway)
ON Associated to AP
Blinking Data Tx/Rx
OFF Not associated with AP
Table 2-2. Transceiver LED Functions (Continued)
LED Label Activity Indication