User's Manual

MDS 05-2806A01, Rev. E.1 MDS iNET 900 Series User’s Guide 15
1.4.1 Early Warning via SNMP Traps
In addition to the operative tools and techniques, the transceiver can
send SNMP traps (alarms) to a network management systems when cer-
tain potentially suspicious activities or events occur. The alarms
include:
• Unauthorized AP MAC address detected at Remote
• Unauthorized Remote MAC address detected at AP
• Login attempt limit exceeded
(Accessed via: Telnet, HTTP, or local)
• Successful login/logout
(Accessed via: Telnet, HTTP, or local)
1.5 ACCESSORIES
The transceiver can be used with one or more of the accessories listed in
Table 1-3. Contact the factory for ordering details.
Unprotected access to configuration via
SNMPv1
•Implement SNMPv3 secure
operation
Intrusion detection
• Provides early warning via SNMP
through critical event reports
(unauthorized, logging attempts,
etc.)
Table 1-2. Security Risk Management
Security Vulnerability MDS iNET 900 Solution
Table 1-3. Accessories
Accessory Description MDS Part No.
AC Power
Adapter Kit
A small power supply module designed for
continuous service. UL approved. Input:
120/220; Output: 13.8 Vdc @ 2.5 A
01-3682A02
Omni-
Directional
Antennas
Rugged antennas well suited for use at Access
Point installations. Consult with your factory
Sales Representative for details
Call factory
Yagi Antenna
(Directional)
Rugged antennas well suited for use at Remote
installations. Consult with your factory Sales
Representative for details.
Call factory
TNC Male-to-N
Female Adapter
One-piece RF adaptor plug. 97-1677A161
TNC Male-to-N
Female Adapter
Cable
Short length of coaxial cable used to connect
the radio’s TNC antenna connector to a Type N
commonly used on large diameter coaxial
cables.
97-1677A159
(3 ft./1m)
97-1677A160
(6 ft./1.8m)
Ethernet RJ-45
Crossover
Cable (CAT5)
Cable assembly used to cross-connect the
Ethernet ports of two transceivers used in a
repeater configuration.
(Cable length ≈ 3 ft./1M)
97-1870A21