User's Manual

108 MDS iNET 900 Series User’s Guide MDS 05-2806A01, Rev. E.1

• TxKey—Manually key the radio transmitter for power mea-

surements. [

Enable, Disable; Disable]

• RSSI—Incoming received signal strength on frequency

entered in the frequency parameter on this screen (–dBm).

This RSSI measurement is updated more frequently than the

RSSI by Zone display of the Performance Information menu.

3.9.6 Ping Utility Menu

Figure 3-59. Ping Utility Menu

• IP Addr—Address to send a PING. [Any valid IP address]

• Count—Number of PING packets to be sent.

• Packet Size—Size of each PING data packet (bytes).

• Go—Send PING packets to address shown on screen.

Screen will be replaced with detailed report of PING activity.

Press any key after viewing the results to return to this menu.

3.9.7 Reset to Factory Defaults

To reset all transceiver parameters back to the factory defaults, you must

enter a special code (authorization key) provided by the factory in place

of the user name.

This procedure is useful when several parameters have been modified,

and there is no track of changes. The transceiver returns to a known

state, where it may be easier to determine the correct settings.

3.9.8 Resetting the Password

The user has the ability to return the iNET password to the default value

admin by entering a specific MDS-supplied authorization key at the