User's Manual

MDS 05-2806A01, Rev. E.1 MDS iNET 900 Series User’s Guide 107
1. At the Reprogramming Menu (Page 92), Enter the AP’s IP Address
in the TFTP Server field.
2. Enter
upgrade_from_ap.ipk in the Filename field.
NOTE: The filename is case sensitive.
3. Perform the firmware download.
3.9.5 Radio Test Menu
This area provides several useful tools for installers and maintainers.
You can manually key the radio transmitter to make measurements of
antenna performance. (See “Antenna Aiming” on Page 125 for details.)
Figure 3-58. Radio Test Menu
Shown with Test Mode set to ON
NOTE : Use of the Test Mode will disrupt traffic through the radio. If
the unit is an Access Point, it will disrupt traffic through the
entire network.
Test Mode function is automatically limited to 10 minutes and
should only be used for brief measurement of transmit power.
It may also be manually reset to continue with the testing or
turned off.
•
Test Mode—Controls access to the transceiver’s suite of tools.
[
ON, OFF; OFF]
• Frequency—Set radio operating frequency during the testing
period to a single frequency. [
915.0000 MHz]
•
TX Output Power—Temporarily overrides the power level set-
ting in the Radio Configuration Menu. [
20]