User Manual

MDS 05-4055A01, Rev. A MDS entraNET 900 System Guide (Preliminary) 27
Device Names Menu
Figure 2-9. Device Names Menu
• Device Name—Device Name, used by the transceiver as
the “Realm” name for network security and menu headings.
• Owner—User defined; appears on this screen only.
• Contact—User defined; appears on this screen only.
• Description—User defined; appears on this screen only.
• Location—User defined; appears on this screen only.
2.3 CONFIGURING NETWORK
PARAMETERS
2.3.1 Network Configuration Menu
The Network Configuration Menu is the home of three parameters that
should be reviewed and changed as necessary before placing an trans-
ceiver in service—Device Mode, IP Address and Network Name.
Screens for both the Access Point and Remote units are shown below.
Invisible place holder
Figure 2-10. Network Configuration Menu
From Access Point
• Network Name (User Review Required)—Name of the network
of which this unit will be a part. Essential for association of
Remotes to the Access Point in the entraNET network. [Not
Programmed]
• IP Address
(User Review Recommended)—Essential for connec-
tivity to the MDS entraNET 900 MS via the
LAN port and Ether-
net data over the network. Enter any valid IP address that will
be unique within the network. [192.168.1.1]
Screen not found in MDS entraNET