Installation Manual

3-18 Installation
MK-MAN-01 CarrierWave Digital Radio
1. Place the mounting plate against the wall.
2. Using a level, be sure that the mounting pole is perpendicular to the ground (J bracket is
optional. Consult factory for part number and supply). You may need to use spacers, as
shown in Figure 3-7.
3. Mark the hole locations for the drilled hole locations. Remove the mounting pole and set
aside.
4. Drill 1/8-inch holes in the places marked.
5. Use #10 or #12 wood screws to secure the mounting pole to the wall and tighten.
Figure 3-7. Optional Mounting Pole J Bracket on Clapboard Siding
Now that you have installed the mounting pole, you are ready to install the CarrierWave ODU
onto the mounting poles. Reference Figures 3-8 through 3-11.