Installation Manual

User Reference and Installation Manual 3-17
CarrierWave Digital Radio MK-MAN-01
3. Tighten nuts equally until mounting pole is secure and cannot rotate.
Figure 3-5. Optional Mounting Pole J Bracket Installed on Pole or Antenna Mast
3.6.2.1.2 Installing on Brick or Masonry
1. Place the mounting plate against the wall. Use a level or plumb line to set the mounting pole
perpendicular to the ground (J-bracket is optional, consult factory for supply and part
number).
2. Mark the hole locations.
3. Set the pole aside.
4. Drill ¼ inch holes at the marked locations. Drill the holes approximately ½ inch deep.
5. Insert the expansion shields into the drilled holes and tap them home.
6. Align the mounting pole with the drilled holes and fix with the lag bolts.
Figure 3-6. Optional Mounting Pole J Bracket Installation
3.6.2.1.3 Installing on a Wall with Wood Siding
Typically 2 ½
inch