User's Manual

MDS 05-3301A01, Rev. C MDS 9810 Installation and Operation Guide 33
SET/PROGRAM COMMANDS
ADDR [1...65000]
Details Page 36
Program network address
AMASK [0000 0000–FFFF
FFFF]
Details Page 36
Sets alarm response. Default is FFFF FFFF.
ASENSE [HI/LO]
Details Page 36
Changes the sense of the alarm output. Default
sense is HI.
BAUD [xxxxx abc]
Details Page 36
Set data communication parameters
CTS [0–255]
Details Page 37
Program CTS delay in milliseconds.
(A value of 0 returns CTS immediately)
CTSHOLD [0-6000]
Details Page 38
Set/display “hold time” that CTS remains
present following last character transmission
from DD-25 port.
DEVICE [DCE, CTS KEY]
Details Page 38
Set device behavior; DCE (normal) or CTS Key
(Repeater)
INIT
Details Page 41
Initialize parameters to factory default values
MODE [M, R, R-M]
Details Page 41
Program operating mode, where M = Master,
R = Remote, R-M = Remote-Master (Remote
radio programmed to operate on Master fre-
quencies)
OWM [xxxxx]
Details Page 42
Program owner’s message
(30 characters maximum)
OWN [xxxxx]
Details Page 42
Program owner’s name
(30 characters maximum)
PWR [xx–30]
Details Page 42
Program forward power output in dBm.
RTU [ON/OFF/0-80]
Details Page 43
Re-enables or disables the radio’s internal RTU
simulator and sets the RTU address.
RXTOT [NONE, 0–1440]
Details Page 43
Specifies max. duration (in minutes) to wait
before issuing a time-out alarm. Default is OFF.
SEND [n, -n, +n]
Details Page 43
Sets/displays re-send count for data packets.
Useful in areas with heavy radio interference.
TDD [ON/OFF]
Details Page 47
Sets or displays time-division multiplex status of
DATA INTERFACE connector. (Sometimes
referred to as “simulated full-duplex” mode.)
UNIT [10000–65000]
Details Page 48
Program unit address. Used to set a unique
address for network-wide diagnostics.
ZONE DATA
Details Page 49
Show zone data statistics. Press “Q” to quit
ZONE CLEAR
Details Page 50
Reset zone data statistics
Table 6. Command Summary (Continued)
COMMAND DESCRIPTION