User Manual

User Reference and Installation Manual 3-29
MDS 5800 II
2. Start a hyperterminal session and select the following COM port settings:
• Bits per second: 38400
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
3. The following terminal and ASCII settings are recommended for best viewing:
• Emulation: VT100
• Line delay: 50 ms
• Character delay: 10 ms
• Text wrap: On
4. Connect to the SDIDU
TM
. Once the connections complete, power on the SDIDU
TM
.
5. Press the keyboard return key to receive a login prompt. Log in.
6. Press the M-key to navigate to the Main Menu.
7. Press the B-key to navigate to Administration.
8. Press the A-key to navigate to Network Configuration.
9. Press the A-key to navigate to General.
10. Press the A-key to navigate to IP Address.
11. Enter the new IP address and press the D-Key to update. If the IP address has been
entered correctly enter Y when prompted.
12. If necessary, use the same menus to set the IP Netmask and IP Gateway.
13. Close the hyperterminal connection.
3.7.3.2 Configuring the SDIDU
TM
Use the GUI to configure the SDIDU
TM
as follows:
1. To start the GUI, open a web browser and use the SDIDU
TM
IP address (192.168.0.1) as
the url and log in when prompted.
2. Use the frame on the left side of the window to navigate to “Radio Link.”