User Manual

User Reference and Installation Manual 3-19
MDS 5800 II
Figure 3-7. Mounting Parts for the MDS 5800 II ODU
1. Remove the pole mount portion of the tilt bracket from the ODU by loosening the middle
bolts and removing the top and bottom bolts on each side.
2. Mount the tilt bracket to the mounting pole using the U-Bolts and nuts. Insert the U-bolts
around the pole and through the holes in the tilt bracket. Install a washer and nut to each
side of the threaded U-bolt and hand tighten. Repeat this step for the second U-bolt.
3. Place the MDS 5800 II ODU on the mating half of the tilt bracket connected by the two
center bolts.
4. Add the remaining four bolts to the tilt bracket but do not tighten until the antenna
alignment is complete (only applies for internal antenna ODUs).
5. Manually point the ODU in the direction of the link partner ODU.
Figure 3-8. MDS 5800 II ODU Rear View