User's Manual

MDS 05-3447A01, Rev. F MDS 1710A/C and MDS 2710A/C/D 5
Invisible place holder
Figure 4. MDS 1710x/2710x Product Configurator Codes
1.5 Accessories
The transceiver can be used with one or more of the accessories listed in
Table 2. Contact Microwave Data Systems for ordering information.
THIS INFORMATION IS
SUBJECT TO
CHANGE.
DO NOT USE FOR
PRODUCT ORDERING.
1710A/C/D,
OPERATION
X= Base/Remote
MODE
N= Non-redundant
INPUT VOLTAGE
1= 10.5 to 16 VDC
MODEM
B= 9600 bps
DIAGNOSTICS
0= None
1= Network-wide
BANDWIDTH
1= 12.5 kHz
3= 25 kHz
FEATURES
0= Full
AGENCY
N= N/A
SAFETY
N= N/A
Mtg. Brackets.
A= Std.
B= None
5= 5 kHz
D= 3200 bps
0= None
C= 19200 bps
RX FRQ. (MHz)
A= 220-240**
A= 130-140
B=140-150
D= 150-165
E= 165-175
TX FRQ. (MHz)
1= 220-240**
2= 140-150
3= 150-165
D= Demo
C= China
F= FCC
I= Ind. Canada
(6.25 kHz @130-174)
2710A/C/D
4= 165-174
1= 130-140
** MDS 2710A/C Models
A= 220-222*
* MDS 2710D Models
1= 220-222*
Table 2. MDS 1710/2710 Series Optional Accessories
Accessory Description MDS P/N
Hand-Held Terminal
Kit (HHT)
Terminal that plugs into the radio for
programming, diagnostics & control.
Includes carrying case, instructions and
cable set.
02-1501A01
RTU Simulator Test module that simulates data from a
remote terminal unit. Comes with MDS
polling software (02-2093Axx) that runs
on a PC. Useful for testing radio
operation.
03-2512A01
Order Wire Module External device that allows temporary
voice communication. Useful during
setup & testing of the radio system.
02-1297A01
Power Supply Kit AC adaptor that converts 110/220 Vac to
12 Vdc at 30 watts.
01-3682A01
Order Wire Handset Used with Order Wire Module (above). 12-1307A01
RJ-11 to DB-9 Adapter Used to connect a PC to the radio’s
DIAG. port
03-3246A01
EIA-232 to EIA-422
Converter Assembly
External adapter plug that converts the
radio’s DATA INTERFACE connector to
EIA-422 compatible signaling.
03-2358A01
TTL Converter
Assembly
External adapter plug that converts the
radio’s DATA INTERFACE connector to
TTL compatible signaling.
03-2223A01