Installation Guide

4. As with the middle Tiles, after inserting the linking cable from the
previous Tile, note that the panel should light up if the cable is
connected correctly. If it does not light up, ensure that the control
box is plugged in and turned on, and re-check your connection.
5. Adhere to wall by using the removable adhesive pads. Stick one side
to the back of the Hexagon Panel and the other side to the wall.
PRESS AND GENTLY HOLD FOR 30 SECONDS.
6. Set up light shows and scenes all through the CYNC app.
7. Enjoy!
Installing Final Panel
1. Rotate the final Hexagon Panel so that the Input Port side aligns
with the Output Port of the previous Hexagon Panel.
2. There’s no Output Port connection required for this Hexagon Panel.
3. Remove the last Layout Template from the wall.
Fasten Hexagon Panels with Nails
(Optional)
Adhesive pads may not adhere to some surfaces, including wallpaper, brick,
textured or porous surfaces. Nails may be required to complete installation.
1. Disconnect the Hexagon Panel from power then use the removal
tool to separate the hexagon panel from bracket.
2. Place the Mounting Bracket on the wall with the Input and Output
Ports facing away from the wall.
3. Gently hammer three Traceless Nails into the provided nail holes.
4. Orient the Hexagon Panel so the Arrows (Output Port) on the
Hexagon Panels and Mounting Bracket align. Gently press the
Hexagon Panel until it clicks into place.
5. Reconnect the Hexagon Panel to the power. Note that the panel
should light up if the cable is connected correctly. If it does not light
up, ensure that the control box is plugged in and turned on, and
re-check your connection.
Removing and Reposition
(If Needed)
To remove:
1. Unplug power.
2. Use the removal tool to separate the Hexagon Panel from the bracket.
3. Pull the tab to stretch the tab slowly against the wall and remove the
bracket & link cable. To avoid elastic damage, use hand to hold the
bracket when pulling. Never pull the adhesive tab toward you
(may damage wall paint).
Note: In case of nail installation, remove the adhesive first, then hold
bracket to pull out nail.
4. Repeat to remove all tiles.
To reposition:
1. Adhesive strips are not reusable, please purchase new adhesive
strips to reinstall.
2. Choose a new design and follow the guide to install.
How to use the Tile Removal Tool
1. The Hexagon Panels can be separated from the Mounting Bracket
by inserting the Panel Remover Tool between the Hexagon Panel
and Mounting Bracket and gently unlatching the Bracket. Repeat on
each side of the bracket.
Note: If Panel Remover Tool is not available, gently pull on only one
side of the Hexagon Panel. Do not pull on Hexagon Panel from two
sides at once as this may cause damage.