Installation Guide

4. Remove the 1st Layout Template from the wall. Leave the other
templates in place for now.
5. Adhere to wall in your first position by using the removable adhesive
pads. Stick one side to the back of the Hexagon Panel and the
other side to the wall. PRESS AND GENTLY HOLD FOR 30 SECONDS.
Installing the First Hexagon Panel
1. Ensure the control box has been connected to the first
Hexagon Panel.
2. Determine the Output Port to connect to the 2nd Hexagon Panel.
Select the Output Port that’s touching the side of the 2nd Hexagon
Panel you’re connecting to.
3. Insert the Linking Cable into the desired Output Port BEFORE
MOUNTING TO WALL.
Download the CYNC App & Power
the First Hexagon Panel
1. Download the Cync App.
2. Connect the control box and power adapter to the first
Hexagon Panel.
3. Connect the control box cable by aligning the tab with the
indentation on the cable and press the connector downwards
to snap into the mounting bracket.
4. Power on the Hexagon Panel.
• Keep lights on during installation to ensure linking cables are
properly connected.
5. Connect to the Cync App and complete setup.
The CYNC App walks through Hexagon Panel
layout and installation step by step. Start with
the CYNC App for the best experience. Use
these instructions for reference.
Preparing the Wall
1. Clean the wall with the provided cleaning wipe and let dry before
moving forward with the installation.
2. Select a pattern in the CYNC App or create your own layout.
3. Use the Layout Template to create your design by peeling the
backing off the removable adhesive and sticking the Layout
Template to your wall.
4. Each Layout Template must be touching at least one flat side
of another Layout Template to complete installation.
5. Adjust and reposition templates until you are satisfied with
your design.
6. Determine the Hexagon Panel that will connect to the Control Box
and Power Adapter (likely the one closest to your wall socket). This
will be the first panel installed in the next step.
Note: Double check your design before proceeding to the next
step. Once the Hexagon Panels are installed, they may be difficult
to readjust.
Installing Middle Panels
Repeat steps to install all middle panels
1. Rotate the next Hexagon Panel so that the Input Port side aligns
with the Output Port of the previous Hexagon Panel.
2. Determine the Output Port to connect to the next Hexagon Panel.
Select the Output Port that’s touching the side of the next Hexagon
Panel you’re connecting to.
3. Insert the Linking Cable into the desired Output Port BEFORE
MOUNTING TO WALL.
4. Remove the Layout Template of the Hexagon Panel you are
installing. Leave the other templates in place for now.
5. Insert the Linking Cable from the previous Hexagon Panel into the
Input Port. After inserting the linking cable from the previous Tile,
note that the panel should light up if the cable is connected correctly .
If it does not light up, ensure that the control box is plugged in and
turned on, and re-check your connection.
6. Adhere to wall by using the removable adhesive pads. Stick one
side to the back of the Hexagon Panel and the other side to the wall.
PRESS AND GENTLY HOLD FOR 30 SECONDS.
Input Port
Input Port
Output Port