User's Manual

LUMEN TERRAIN User Manual
25
Chapter 2. Installation
2.5. Sensor Node Installation
This section will guide you through the installation of the Sensor Node enclosure, solar panel, weather
station, and necessary electrical connections.
2.5.1. Sensor Node Enclosure Installation
After a pole with the requirements mentioned in Section 2.3.1.2 is installed or located, the Sensor
Node enclosure can be mounted. The enclosure should be installed at a recommended height of
64 inches measured from the base of the pole to the top surface of the enclosure.
When the enclosure is raised to the specified height, insert the 2 inches U-bolts onto the
elongated holes of the enclosure as shown in Figure 13 and torque the U-bolts to 90 in-lbs. Ensure
that the backplate rests on the pole itself and not on the flange of the enclosure.
Figure 13: Node Enclosure Installation