Installation Guide

31-11161 04-18 GEA (sheet 2 of 2)
11
OVEN RACK GUIDE INSTALLATION
A. Locate included oven rack guide mounting hardware.
B. Place oven rack guides on cavity wall studs with metal posts towards back of cavity as shown.
C. Install guides using the 8 provided mounting nuts.
Oven rack
guide shown
in place.
Metal Posts to
be installed in
the rear of cavity
French doors removed
for illustration clarity only
French doors removed
for illustration clarity only
12
DOOR ADJUSTMENT MECHANISM
Door Adjustment Mechanism is located on both the right and left doors at the bottom hinges. Only
the left side Adjustment Mechanism is shown in this manual.
NOTE: Adjust the doors inward only until the center gap is even. Over-adjusting can damage the
center seals and make the doors more difficult to open.
A. Using 3/16” hex key, tighten Vertical Adjustment Screw to adjust door up and loosen to adjust
door down.
B. Horizontal Adjustment Screws pivot
the door about an axis. Using a 1/8”
Hex Key, loosen both screws, then
tighten appropriate screw to pivot
door. Once door is in place, verify
both screws are tightened.
EXAGGERATED EXAMPLES FOR LEFT DOOR ADJUSTMENT
Example 1: Left door low,
center gap even.
Steps for adjustment:
A. Tighten left Vertical
Adjustment Screw.
B. If left door is still low, loosen
right Vertical Adjustment
Screw.
Example 2: Left door low,
center gap larger at bottom.
Steps for adjustment:
A. Loosen inside Horizontal
Adjustment Screw.
B. Tighten outside Horizontal
Adjustment Screw until
center gap even.
C. If left door is still low, tighten
left Vertical Adjustment
Screw.
D. Tighten inside Horizontal
Adjustment Screw.
Example 3: Left door high,
center gap larger at top.
Steps for adjustment:
A. Loosen outside Horizontal
Adjustment Screw.
B. Tighten Outside Horizontal
Adjustment Screw until
center gap even.
C. If left door is still low, tighten
Left Vertical Adjustment
Screw.
D. Tighten Inside Horizontal
Adjustment Screw.
Vertical Adjustment Screw
Horizontal Adjustment Screws
Some models have custom handles. Please follow the instructions with the handles for
proper installation.