Installation Guide

31-11162 04-18 GEA (sheet 1 of 2)

ELECTRICAL REQUIREMENTS

WARNING

This appliance must be properly grounded.

WARNING

To prevent fire or shock, do not use an extension cord with this appliance.

WARNING

To prevent shock, remove house fuse or open circuit breaker before beginning

installation.

WARNING

Improper connection of aluminum house wiring to copper leads can result in an

electrical hazard or fire. Use only connectors designed for joining copper to aluminum and follow the

manufacturer’s recommended procedure closely.

We recommend you have the electrical wiring and hookup of your appliance connected by a qualified

electrician. After installation, have the electrician show you how to disconnect power from the appliance.

You must use a single-phase, 120/208 VAC or 120/240 VAC, 60 Hertz electrical system. If you connect

to aluminum wiring, properly installed connectors approved for use with aluminum wiring must be used.

Effective January 1, 1996, the National Electrical Code requires that new construction (not existing)

utilize a four-conductor connection to an electric oven. When installing an electric oven in new

construction, a mobile home, recreational vehicle or an area where local codes prohibit grounding

through the neutral conductor, refer to the section on four-conductor branch circuit connections.

Check with your local utilities for electrical codes which apply in your area. Failure to wire your oven

according to governing codes could result in a hazardous condition. If there are no local codes, your

oven must be wired and fused to meet the National Electrical Code, NFPA No. 70 – latest edition,

available from the National Fire Protection Association.

3 C

CUTOUT FOR FRENCH DOOR UNDER A

MICROWAVE/ADVANTIUM AND OVER A WARMING

DRAWER

NOTE: Install the oven only with specific models listed on the label located on top of the oven.

NOTE: Additional clearances between cutouts may be required. Check to be sure the oven

supports above the Warming Drawer location do not obstruct the required interior depth and height.

When installing a Warming Drawer below a single or double oven, a separate 120V, 60 HZ,

properly grounded receptacle must be installed. Refer to installation instructions packed with

the Warming Drawer for specific installation requirements.

27 1/4" min.

2" min.

1" min.

16 1/4" min.

Dimensions Per

Microwave/Advantium

Requirements

Dimensions Per

Warming Drawer

Requirements