ZONELINE® I UltimateV10 TM VERTICAL AIR CONDITIONERS AZ95 SINGLE PACKAGED VERTICAL UNITS ENGINEERING DATA MANUAL
I ZON E L I N E ® Ul t i mate V1 0 TM GE Appliances changes the industry THE ULTIMATE standard for Vertical Air Conditioners. The Zoneline UltimateV10 Vertical AC is designed with 10 exclusive features and innovations that make ownership simple, efficient and easy! We provide the ultimate owner experience by solving design challenges that others miss. EXPLORE THE 10 1 Insta-Platform™ * One-piece design fully integrates with the wall plenum and aligns for a tight seal.
OWNER EXPERIENCE EXCLUSIVE FEATURES 3 Fast-Connect Plumbing* Thoughtful design enables platform build and rough plumbing completed in only minutes 5 Self-Aligning, Lock-in-Place System Perfect fit and mistake proof when the chassis is placed on the platform 7 Reverse Cycle Defrost Exclusive technology increases efficiency, enabling the unit to run in heat pump mode longer 4 Quick-Install Plenum Plenum is easily installed from the interior of building, without the need for exterior building access** 6 O
V E R T I C AL A IR CO N DITIO N E R SPECI FI CATI ONS AZ95 SERIES - 230/208V MODELS* COOLING WITH ELECTRIC HEAT SPECIFICATIONS Features Cooling BTU AZ95E09DAC AZ95E12DAC AZ95E18DAC 9200 11500 17200 EER (Minimum) 11.5 12.1 11.2 Cooling Power (W) 795 940 1520 Cooling Current (A) 3.6 4.3 7.3 Sensible Heat Ratio (SHR) 74% 73% 70%** Dehum (Pints per Hour) 2.2 2.8 4.7** R-410A R-410A R-410A CFM @ 0.1 ESP (med fan) 408 408 468 CFM @ 0.
ACCE S SO R I E S ESSENTIAL ACCESSORIES Zoneline Vertical Air Conditioners require a set of essential accessories for proper operation.
ACCE S SO R I E S (co n t i n u e d) PLENUM ADAPTERS RAVTRANS2 Plenum adapter to transition from existing AZ75/ AZ85 wall plenum to AZ95 unit RAVTRANS3 Plenum adapter to transition from existing AZ90/AZ91 shallow plenum (RAVWPT8) to AZ95 unit RAVTRANS4 Plenum adapter to transition from existing AZ90/AZ91 deep plenum (RAVWPT14) to AZ95 unit R E MOT E T H E RMOSTATS All Zoneline Vertical units are compatible with GE Appliances’ wall-mounted remote thermostats.
ZO N E LI N E U l t i m a teV 1 0 AI R CO N D ITI O N E R SYSTEM FEATURES The Zoneline UltimateV10 Single Packaged Vertical air conditioner is designed with features and innovations making it the ideal unit to own.
FE AT U R ES & B E N E F ITS EXCELLENT EFFICIENCY AND DEHUMIDIFICATION GE Appliances recognizes the importance of energy efficiency and dehumidification in an air conditioning system and uses EER (Energy Efficiency Rating) as the required means of reporting the relative cooling efficiency of the unit. The measurement of the efficiency of the heat pump output, when compared to electric resistance heat, is called the Coefficient of Performance (COP).
F E AT U R E S & B E N E F ITS TRANSFER FAN INTERFACE INDOOR COIL FROST CONTROL The advantage of the Zoneline Vertical chassis product is the ability to duct air to other rooms. If it is desired to move air into a space where there is no ducting, a 24 VAC connector (RAKCDC) is available to operate a relay that controls a wall mounted fan that transfers air from one room to another. With this, the wall mounted fan would turn on whenever the indoor fan of the unit operates.
F E AT U R ES & B E N E F ITS HEAT PUMP OPERATION HEAT PUMP DEFROST Heat pumps save money compared to electric resistance heat, but if the unit cannot provide room occupant comfort, the savings may be of questionable benefit. GE Appliances has years of experience with designing Zoneline heat pumps to solve the problem of guest complaints. The heat pump unit uses a two-stage heat/one-stage cooling thermostat.
CO M P O N E NT S & I N STALL ATI O N Each Zoneline single packaged vertical unit requires a drain platform, wall plenum, exterior grille, unit, remote thermostat, filter and a return air grille, ductwork and supply registers. The drain platform legs, ductwork and supply registers are field supplied. Each of the other components is ordered separately.
CO M P O N E NT S & I N STALL ATI O N STANDARD SIZE AIR FILTER A number of filters, providing varying degrees of filtering efficiency, are available on the market today. GE Appliances has designed the Zoneline Vertical chassis to accommodate a number of filter placement options. The filter provided with the unit is a standard size 18" W x 20" H x 1" D filter. The unit must not be operated without a filter in place, even during construction.
CO M P O N E NT S & I N STALL ATI O N RETURN AIR GRILLE, ACCESS PANEL OR LOUVERED CLOSET DOOR The return air from the room to the unit may enter the closet through one of four ways. A louvered door may be installed on the closet to allow return air to enter. When a louvered door is used, the filter would be installed in the filter bracket on the front panel of the unit. A wall-mounted access panel may be used instead of a louvered door.
CO M P O N E NT S & I N STALL ATI O N REMOTE THERMOSTAT Zoneline Vertical units are controlled by a wall-mounted thermostat. GE Appliances offers a complete line of thermostats to interface with the units, or most 24-VAC thermostats may be used. Low voltage wiring connections are made to the 8 pin harness included with each unit. This harness allows for a single point thermostat connection to simplify chassis removal and reinstallation. See diagram below for terminal designations.
T Y P I C AL UTI LIT Y CLOS E T AN D D I M E N S I O N S (FOR REFERENCE ONLY) FRONT INSTALL SIDE INSTALL Top View Top View Architectural Louver Architectural Louver 10” Duct 13½” 27 ¾” minimum 7.16” 3” minimum clearance 10” Duct 13½” 3” minimum clearance 3” minimum clearance 3” minimum clearance Door/access panel 7.
AUX I L I A RY CO N TR O LS SETTING THE AUXILIARY CONTROL Auxiliary Controls-Aux Set Button The electronic control for the unit comes preset from the factory to control the unit how “most” customers would prefer the unit to operate. The presets (called modes or functions) can be modified to accommodate for differences in installation parameters or personal preferences on how the unit should operate and perform.
AUX I L I A RY CO N TR O LS SETTING THE AUXILIARY CONTROL Mode 3 Freeze Sentinel/Heat Sentinel With power to the unit and Freeze Sentinel activated, the unit automatically provides heat without user interface. This prevents potential plumbing damage by turning the heater and indoor fan ON at 41o F and then OFF once the room temperature reaches 46o F. When Heat Sentinel is activated, the unit automatically provides cooling without user interface.
ACCE S SO R I E S 23-3/4″ 26-1/2″ ARCHITECTURAL LOUVER RAVAL3 Cutout Dimensions: 24" W x 32" H RAVDPLAT Drain Platform WALL PLENUM RAVWPT15 Telescopes from 8” to 15” 32-5/8″ 23-31/32″ 31-3/4″ 3-5/8″ 24-35/64″ 8″- 15″ 1-1/4″ RETURN AIR GRILLE RAVRG2 Filter size: 20" x 20" Field supplied 29-3/8″ ACCESS PANEL WITH RETURN AIR GRILLE RAVRG4 Filter size: 20" x 24" x 1 or 2” Field supplied 22-1/2" OR 57-3/8″ Cutout Dimensions: 28-1/8" W x 55-7/8" H 22-1/2" Cutout Dimensions: 20-3/8" W x 20-3/8"
S P ECI F I C ATI O N S The following are suggested specifications for the AZ95 Series single packaged vertical units: The contractor shall furnish single packaged vertical units of the sizes and capacities shown on the schedule or in the specifications. The units shall be located as shown on the drawings and each shall consist of a chassis, appropriately sized wall plenum, outdoor grille, remote wall thermostat, drain platform, and closet access panel or door.
GE A P P L I AN C E S VE R TIC A L ZONELI NE HEAT PUMPS ADDI TI ONAL S PE C I F I C AT I ON S Heat pump unit shall automatically switch from heat pump operation to electric resistance heat when it is unable to provide sufficient heat to maintain room temperature or when the outdoor temperature is 25o F or less.
ZON E L I N E WA R R A N TY Proof of original purchase date is needed to obtain service under warranty. For service in the U.S., call 1-844-GE4-PTAC (1-844-434-7822). In Canada, contact your local distributor. WHAT IS NOT COVERED WHAT IS COVERED If you have an installation problem, or if the air conditioner is of improper cooling capacity for the intended use, contact your dealer or installer. You are responsible for providing adequate electrical connecting facilities.
Preliminary specifications. Subject to change.
Preliminary specifications. Subject to change.
GE is a trademark of the General Electric Company. Manufactured under trademark license. Copyright ©2020 GE Appliances. All rights reserved. Zoneline, UltimateV10 and other names are trademarks or registered trademarks of GE Appliances in the United States and other countries. Appliance Park Louisville, KY 40225 geappliances.com zoneline.com I 888.231.
