Sales Guide

14
ZONELINE
®
MUST-HAVES
WALL SLEEVE
Heavy-gauge galvanized steel with
a baked enamel finish for outstanding
protection and appearance.
RAB71A wall sleeve
Heavy-gauge galvanized steel,
with insulation. A—42", B—13-3/4", C—16"
RAB77A4 wall sleeve (shown below)
Molded SMC fiberglass-reinforced polyester
compound. A—42-1/8", B—13-7/8", C—16-1/4"
Wall opening dimensions
Add 1/4" to A and C dimensions
for all cutout sizes.
RAB71A 16-1/4" min. H x 42-1/4" min. W
RAB71A available in 16", 24", 28" and 31" depths.
RAB77A4 16-1/2" min. H x 42-3/8" min. W
B
C
A
GRILLE OPTIONS
Extruded aluminum: RAG67 (Shown)
Stamped aluminum grille: RAG60
Exterior architectural louvers
Durable polycarbonate:
RAG61 (Warm Grey Beige)
RAG62 (Maple)
RAG63 (Bittersweet Chocolate)
Retrofit kits (Not shown)
RAK901L - Wall Case Insulation kit
RAK40 - Deflector Kit to adapt
chassis for use with existing exterior
architectural louvered grilles
Requires power connection kit
ELECTRICAL CONNECTION
230/208 volt units may be plugged into a receptacle.
265 volt units are provided with a junction box and require
direct connection. (NEC Requires 265V Direct Connection.)
See Architects and Engineers Design Data Manual
for electrical connection information including use
of sub-base for direct-connected units. Installation
must comply with local electrical codes and regulations.
DUCTED APPLICATIONS
6100 and 4100 series can be used with ductwork to heat
or cool more than one room. RAK6052 Duct Adapter
is applied to top of case over air discharge. RAK601
Duct Extension is applied to right or left of adapter. For
additional information on ducted applications, including
special adapters for replacement units, refer to Architects
and Engineers Design Data Manual.
Room
cabinet
Chassis
Wall sleeve (optional)
RAB71A (Shown)
RAB77A4 (SMC) (Not shown)
Cross-flow blower
Grille